Alcatel-Lucent 7950 Quality Of Service Manual page 119

match
Syntax match [next-header next-header]
no match
Context config>qos>network>ingress>ipv6-criteria>entry
Description
This command creates a context to configure match criteria for a network QoS policy match IPv6
criteria. When the match criteria have been satisfied the action associated with the match criteria is
executed.
If more than one match criteria (within one match statement) are configured, then all criteria must
be satisfied (AND function) before the action associated with the match is executed.
A match context can consist of multiple match criteria, but multiple match statements cannot be
entered per entry.
It is possible that a network ingress policy includes the dscp map command, the dot1p map
command, and an IPv6 match criteria. When multiple matches occur for the traffic, the order of
precedence is used to arrive at the final action. The order of precedence is as follows:
1. 802.1p bits
2. DSCP
3. IP Quintuple
The no form of this command removes the match criteria for the entry-id.
Parameters
next-header next-header — Specifies the next meader to match.
The protocol type such as TCP / UDP / OSPF is identified by its respective protocol number. Well-
known protocol numbers include ICMP(1), TCP(6), UDP(17).
Values
dscp
Syntax dscp dscp-name
no dscp
Context config>qos>network>ingress>ip-criteria>entry>match
config>qos>network>ingress>ipv6-criteria>entry>match
Description
This command configures a DiffServ Code Point (DSCP) code point to be used as a network
ingress QOS policy match criterion.
7950 XRS Quality of Service Guide
protocol numbers accepted in DHB: 0 — 42, 45 — 49, 52 — 59, 61 — 255
keywords: none, crtp, crudp, egp, eigrp, encap, ether-ip, gre, icmp, idrp, igmp, igp, ip,
ipv6, ipv6-icmp, ipv6-no-nxt, isis, iso-ip, l2tp, ospf-igp, pim, pnni, ptp, rdp, rsvp, stp, tcp,
udp, vrrp
* — udp/tcp wildcard
Page 119