Alcatel-Lucent 7950 Quality Of Service Manual page 373

Once a policer is created, it cannot be deleted from the queue-group template unless any forwarding classes
that are redirected to the policer are first removed.
The no form of this command deletes the policer.
Parameters
policer-id — The policer-id must be specified when executing the policer command. If the specified ID
already exists, the system enters that policer's context to allow the policer's parameters to be modified. If the
ID does not exist and is within the allowed range for the QoS policy type, a context for the policer ID will be
created (depending on the system's current create keyword requirements which may require the create
keyword to actually add the new policer ID to the QoS policy) and the system will enter that new policer's
context for possible parameter modification.
Values
port-redirect-group
Syntax port-redirect-group {queue queue-id | policer policer-id [queue queue-id]}
no port-redirect-group
Context config>qos>network>egress>fc
Description
This command is used to redirect the FC of a packet of a PW or network IP interface to an egress port queue-
group.
It defines the mapping of a FC to a queue-id or a policer-id and a queue-id and redirects the lookup of the
queue or policer of the same ID in some egress port queue-group instance. However, the queue-group name
and instance are explicitly provided only at the time the network QoS policy is applied to egress context of a
spoke-sdp or a network IP interface.
The no version of this command removes the redirection of the FC.
Parameters
queue queue-id — The specified queue-id must exist within the queue-group template applied to the egress
context of the port.
Values
policer policer-id — The specified policer-id must exist within the queue-group template applied to the
egress context of the port
Values
7950 XRS Quality of Service Guide
1—32 ingress
1—8 egress
1—8
1—8
Page 373