Alcatel-Lucent 7950 Quality Of Service Manual page 228

Service Ingress QoS Policy Forwarding Class Commands
low-burst-max-class
Syntax low-burst-max-class class-id
no low-burst-max-class
Context config>qos>sap-egress>hsmda-queues>queue
Description
This command assigns the low burst maximum class to associate with the HSMDA queue.
The no form of the command returns the class id for the queue to the default value.
Parameters class-id — Specifies the class identifier of the low burst max class for the HSMDA queue.
Values
wrr-weight
Syntax wrr-weight value
no wrr-weight
Context config>qos>sap-egress>hsmda-queues>queue
Description This command assigns the weight value to the HSMDA queue.
The no form of the command returns the weight value for the queue to the default value.
Parameters
percentage — Specifies the weight for the HSMDA queue.
Values
slope-policy
Syntax slope-policy hsmda-slope-policy-name
no slope-policy
Context config>qos>sap-egress>hsmda-queues>queue
Description This command associates an existing HSMDA slope policy to the QoS policy HSMDA queue. The specified
hsmda-slope-policy-name must exist for the command to succeed. If the policy name does not exist, the
command has no effect on the existing slope policy association. Once a slope policy is associated with a
QoS policy queue, subscriber profile override or SAP override, the slope policy cannot be removed from the
system. Any edits to an associated slope policy are immediately applied to the queues using the slope policy.
Within the ingress and egress QoS policies, packets are classified as high priority or low-priority. For color
aware policies, packets are also potentially classified as in-profile, out-of-profile or profile-undefined. Based
on these classifications, packets are mapped to the RED slopes in the following manner:
Ingress Slope Mapping
•
Page 228
1— 32
1— 32
In-Profile — High Slope (priority ignored)
7950 XRS Quality of Service Guide