Egress Network Ip Interface Statistics - Alcatel-Lucent 7950 Quality Of Service Manual

Egress Network IP Interface Statistics

The statistics for network interfaces work differently than statistics on SAPs. Counter sets are
created for each egress IP interface and not per egress queue. When a forwarding class for an
egress IP interface is redirected from the default egress port queue to a queue group queue, the
system continues to use the same counter set.
Separate Ingress IPv4 and IPv6 Statistics
This feature adds support for separate ingress IPv4 and IPv6 statistics on IP interfaces. IES and
VPRN interfaces, and subscriber group interfaces on IES and VPRN, as well as for uRPF. In
previous release, the ingress statistics for IPv4 and IPv6 traffic was combined into a single set of
packet and bytes counters. The existing counters will now only count IPv4 traffic, while new
separate counters are available to IPv6 traffic.
The feature introduces a new CLI command to explicitly enable ingress statistics on IP interfaces,
changing the default to disabled.
7950 XRS Quality of Service Guide
Ingress and Egress Queue Group Creation and Redirection
Page 327