Alcatel-Lucent 7950 Quality Of Service Manual page 301

Group (LAG). When this is true, the show command may display the calculated slowest accurate visitation
time for the logical queue (all hardware queues will have the same calculated value) but must display the
BCG name for each individual hardware queue.
The BCG name associated with a queue may be specified in the show bcg command to display the historical
and current visitation time for the BCG managing the burst tolerance of the queue. If the output visitation
time is greater (longer time) than the queue returned slowest accurate visitation time, the queue's shaping
rate may be negatively impacted.
Parameters from — The from keyword specifies that the following parameters are match criteria for finding a single or
set of ingress or egress queues within the system. The system will accept sap, queue-group, network-
queues as the match criteria.
sap sap-id — The sap keyword is used to specify that the system should find and display the BCG and
calculate the slowest accurate visitation time for the queues within the specified sap-id. The sap
keyword is mutually exclusive with the other from match criteria. If the specified sap-id is not found,
the system should return 'The specified SAP ID does not exist'.
queue-group port-id queue-group-name — The queue-group keyword is used to specify that the system
should find and display the BCG and calculate the slowest accurate visitation time for the queues within
the specified queue-group-name on the specified port-id. The following ingress or egress keyword
further specifies that the targeted queue group is an ingress port or egress port queue group. The queue-
group keyword is mutually exclusive with the other from match criteria. If the specified port-id is not
provisioned on the system or the specified queue-group-name is not found on the ports specified
direction, the system should return 'The specified queue group does not exist'.
network {mda-id | port-id} — The network keyword is used to specify that the system should find and
display the queue informationfor the queues associated with the specified mda-id or port-id. If the
ingress direction qualifier is specified, an mda-id is required. If the egress direction qualifier is
specified, a port-id is required. The network keyword is mutually exclusive with the other from match
criteria. If the specified mda-id does not exist, the system should return 'The specified MDA is not
provisioned'. If the specified port-id does not exist, the system should return 'The specified port is not
provisioned'.
system {card slot-number |mda-id | port-id} — The system keyword is used to specify that the system
should find and display the queue information for all the system queues associated with the specified
card slot-id, mda mda-id or port port-id. If the ingress direction qualifier is specified, the ingress system
queues are displayed. If the egress direction qualifier is specified, only the egress system queues are
displayed. The system keyword is mutually exclusive with the other from match criteria. If the specified
slot-id does not exist, the system should return 'The specified slot number is not provisioned'. If the
specified mda-id does not exist, the system should return 'The specified MDA is not provisioned'. If the
specified port-id does not exist, the system should return 'The specified port is not provisioned'. The id
parameter is not supported when matching system queues.
{ingress | egress} — The ingress and egress direction qualifiers are mutually exclusive. Either ingress or
egress must be specified.
id queue-id — The id keyword is used to limit the return queues to a single queue-id. The keyword is not
accepted when the system match criteria is used.
7950 XRS Quality of Service Guide Page 301