Alcatel-Lucent 7950 Quality Of Service Manual page 502

Generic Commands
Port Scheduler Policy Commands
port-scheduler-policy
Syntax no] port-scheduler-policy port-scheduler-name
[
Context config>qos
Description
When a port scheduler has been associated with an egress port, it is possible to override the following
parameters:
•
•
•
The orphan priority level (level 0) has no configuration parameters and cannot be overridden.
The no form of the command removes a port scheduler policy from the system. If the port scheduler policy
is associated with an egress port, the command will fail.
Parameters
port-scheduler-name — Specifies an existing port scheduler name. Each port scheduler must be uniquely
named within the system and can be up to 32 ASCII characters in length.
dist-lag-rate-shared
Syntax [no] dist-lag-rate-shared
Context config>qos>port-scheduler-policy
Description
This command enables sharing of rates when the port on which this port-scheduler-policy is configured is
part of a LAG configured in distribute mode.
When enabled, the absolute rate values configured as part of the max-rate, PIR/CIR group rates and PIR/
CIR level rates are shared across the member ports of the LAG when configured in distribute mode.
This command does not have any affect when the port on which this port-scheduler-policy is configured is
part of a LAG in link mode. Similarly when rates are configured as percent-active rates, the value of this
object is irrelevant.
Page 502
The max-rate allowed for the scheduler
The maximum rate for each priority level (8 through 1)
The cir associated with each priority level (8 through 1)
7950 XRS Quality of Service Guide