Alcatel-Lucent 7950 Quality Of Service Manual page 370

Queue Group Commands
Queue Group Commands
queue-group-templates
Syntax queue-group-templates
Context config>qos
Description
This command enables the context to define ingress and egress queue group templates.
Default
none
egress
Syntax egress
Context cfg>qos>qgrps
Description
This command enables the context to configure QoS egress queue groups. Egress queue group templates can
be applied to egress Ethernet ports to create an egress queue group.
Default none
queue-group
Syntax queue-group queue-group-name [create]
no queue-group queue-group-name
Context cfg>qos>qgrps>egr
cfg>qos>qgrps>ingr
Description This command creates a queue group template. The system does not maintain default queue groups or queue
group templates. Each queue group template used in the system must be explicitly created.
The queue-group-name parameter is required when executing the queue-group command and identifies the
name of the template to be either created or edited. Each ingress queue group template must be uniquely
named within the system. Multiple ingress queue group templates may not share the same name. An ingress
and egress queue group template may share the same name.
The no form of the command removes the specified queue group template from the system. If the queue
group template is currently in use by an ingress port, the command will fail. If group-name does not exist,
the command has no effect and does not return an error.
Default
none
Parameters
queue-group-name — Specifies the name of the queue group template up to 32 characters in length.
Page 370 7950 XRS Quality of Service Guide