Deleting Qos Policies - Alcatel-Lucent 7950 Quality Of Service Manual

Deleting QoS Policies

A slope policy is associated by default with and port access and network egress pools. A default
policy may be replaced with a non-default policy, but a policy cannot be entirely removed from the
configuration. When a non-default policy is removed, the policy association reverts to the default
slope policy policy-id default. A QoS policy cannot be deleted until it is removed from all or
ports where it is applied.
ALA-7>config>qos# no slope-policy slopePolicy1
MINOR: QOS #1902 Slope policy has references
ALA-7>config>qos#
Global
Use the following CLI syntax to remove slope policies from network egress and ingress pools.
CLI Syntax: config> card 1 mda 1 network ingress pool no slope-policy name
port
The following CLI syntax examples can be used to remove slope policies from MDAs:
CLI Syntax: config>card>mda>access>ingress>pool# no slope-policy name
The following CLI syntax example configures the PPP multilink pool:
CLI Syntax: config>card>mda>access>egress>pool# no slope-policy name
Ports
The following CLI syntax examples can be used to remove slope policies from ports:
CLI Syntax: config>port>access>egress>pool# no slope-policy name
7950 XRS Quality of Service Guide
config>card>mda>network>egress>pool# no slope-policy name
config>port>network>egress>pool# no slope-policy name
Slope QoS Policies
Page 527