Alcatel-Lucent 7950 Quality Of Service Manual page 224

Service Ingress QoS Policy Forwarding Class Commands
queue
Syntax queue queue-id [{group queue-group-name [instance instance-id]} | port-redirect-group-
queue]
no queue
Context config>qos>sap-ingress>fc
config>qos>sap-egress>fc
Description
This command overrides the default queue mapping for fc fc-name. The specified queue-id must exist
within the policy before the mapping can be made. Once the forwarding class mapping is executed, all
traffic classified to fc-name on a SAP using this policy.
The no form of this command sets the queue-id back to the default queue for the forwarding class (queue 1).
Default no queue
Parameters queue-id — Specifies the SAP egress queue-id to be associated with the forwarding class. The queue-id
must be an existing queue defined in sap-egress policy-id.
Values
Default
group queue-group-name — This optional parameter is used to redirect the forwarding type within the for-
warding class to the specified queue-id within the queue-group-name. When the policy is applied, all
packets matching the forwarding class and forwarding type will be redirected to the queue within the
specified queue group. The queue-group-name are configured in the config>qos>queue-group-tem-
plates egress and ingress contexts. This parameter is used when policy based queue group redirection is
desired. That is, the specific queue group to redirect to is named in the QoS policy.
instance instance-id — This parameter is used to specify the specific instance of a queue group with
template queue-group-name to which this queue should be redirected. This parameter is only valid for
queue groups on egress ports where policy based redirection is required.
Values
Default
port-redirect-group-queue — This keyword is used to mark a given forwarding class queue for
redirection to an egress queue group queue. This is only used when the specific queue group instance is
assigned at the time the QOS policy is applied to the SAP. This redirection model is known as SAP
based redirection.
hsmda-queues
Syntax hsmda-queues
Context config>qos>sap-egress
Description
This command enables the context to configure queue definitions for use on SAPs or subscribers on HSM-
DAs. A single QoS policy simultaneously defines queues for both standard MDA and for HSMDA subscrib-
Page 224
1 — 8.
1
1 — 40960
1
7950 XRS Quality of Service Guide