Alcatel-Lucent 7950 Quality Of Service Manual page 174
Extensible routing system
Hide thumbs
Also See for 7950:
- Quality of service manual (912 pages) ,
- Configuration manual (778 pages) ,
- Basic system configuration manual (576 pages)
Table of Contents
Advertisement
Generic Commands
Operational Commands
copy
Syntax
copy sap-egress src-pol dst-pol [overwrite]
copy sap-ingress src-pol dst-pol [overwrite]
Context
config>qos
Description
This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
The copy command is a configuration level maintenance tool used to create new policies using existing
policies. It also allows bulk modifications to an existing policy with the use of the overwrite keyword.
Parameters
sap-egress src-pol dst-pol — Indicates that the source policy ID and the destination policy ID are sap-
egress policy IDs. Specify the source policy ID that the copy command will attempt to copy from and
specify the destination policy ID to which the command will copy a duplicate of the policy.
Values
sap-ingress src-pol dst-pol — Indicates that the source policy ID and the destination policy ID are SAP
ingress policy IDs. Specify the source policy ID that the copy command will attempt to copy from and
specify the destination policy ID to which the command will copy a duplicate of the policy.
Values
overwrite — Specifies to replace the existing destination policy. Everything in the existing destination
policy will be overwritten with the contents of the source policy. If overwrite is not specified, an error
will occur if the destination policy ID exists.
renum
Syntax
renum old-entry-number new-entry-number
Context
config>qos>sap-ingress>ip-criteria
config>qos>sap-egress>ip-criteria
config>qos>sap-ingress>ipv6-criteria
config>qos>sap-egress>ipv6-criteria
config>qos>sap-ingress>mac-criteria
config>qos>network>ingress>ip-criteria
config>qos>network>ingress>ipv6-criteria
Description
This command renumbers existing QoS policy criteria entries to properly sequence policy entries.
This can be required in some cases since the router exits when the first match is found and executes the
actions in accordance with the accompanying action command. This requires that entries be sequenced
Page 174
1 — 65535
1 — 65535
SR>config>qos# copy sap-egress 1 1010
MINOR: CLI Destination "1010" exists use {overwrite}.
SR>config>qos# copy sap-egress 1 1010 overwrite
7950 XRS Quality of Service Guide
Advertisement
Table of Contents
