Alcatel-Lucent 7950 Quality Of Service Manual page 249

All packets with a source MAC OUI value of 00-03-FA subject to a match condition should be specified
as: 0003FA000000 0x0FFFFF000000
Default
Values
etype
Syntax etype etype-value
no etype
Context config>qos>sap-ingress>mac-criteria>entry
Description
Configures an Ethernet type II value to be used as a service ingress QoS policy match criterion.
The Ethernet type field is a two-byte field used to identify the protocol carried by the Ethernet frame. For
e.g. 0800 is used to identify the IP v4 packets.
The Ethernet type field is used by the Ethernet version-II frames. IEEE 802.3 Ethernet frames do not use the
type field. For IEEE 802.3 frames use the dsap, ssap or snap-pid fields as match criteria.
The snap-pid field, etype field, ssap and dsap fields are mutually exclusive and cannot be part of the same
match criteria.
The no form of this command removes the previously entered etype field as the match criteria.
Default
None
Parameters
etype-value — The Ethernet type II frame Ethertype value to be used as a match criterion expressed in
hexadecimal.
Values
snap-oui
Syntax snap-oui {zero | non-zero}
no snap-oui
Context config>qos>sap-ingress>mac-criteria>entry
Description
Configures an IEEE 802.3 LLC SNAP Ethernet frame OUI zero or non-zero value to be used as a service
ingress QoS policy match criterion.
The no form of this command removes the criterion from the match criteria.
Default none
Parameters zero — Specifies to match packets with the three-byte OUI field in the SNAP-ID set to zero.
non-zero — Specifies to match packets with the three-byte OUI field in the SNAP-ID not set to zero.
7950 XRS Quality of Service Guide
0xFFFFFFFFFFFF (hex) (exact match)
0x00000000000000 — 0xFFFFFFFFFFFF (hex)
0x0600 — 0xFFFF
Page 249