Alcatel-Lucent 7950 Quality Of Service Manual page 216

Service Ingress QoS Policy Forwarding Class Commands
Service Ingress QoS Policy Forwarding Class Commands
broadcast-queue
Syntax broadcast-queue queue-id [group queue-group-name]
Context config>qos>sap-ingress>fc fc-name
Description
This command overrides the default broadcast forwarding type queue mapping for fc fc-name. The specified
queue-id must exist within the policy as a multipoint queue before the mapping can be made. Once the
forwarding class mapping is executed, all broadcast traffic on a SAP using this policy will be forwarded
using the queue-id.
The broadcast forwarding type usually tracks the multicast forwarding type definition. This command
overrides that default behavior.
The no form of the command sets the broadcast forwarding type queue-id back to the default of tracking the
multicast forwarding type queue mapping.
Parameters
queue-id — The queue-id parameter must be an existing, multipoint queue defined in the
config>qos>sap-ingress context.
Values
Default
group queue-group-name — This optional parameter is used to redirect the forwarding type within the for-
warding class to the specified queue-id within the queue-group-name. When the policy is applied, all
packets matching the forwarding class and forwarding type will be redirected to the queue within the
specified queue group. The queue-group-name are configured in the config>qos>queue-group-tem-
plates egress and ingress contexts.
de-1-out-profile
Syntax [no] de-1-out-profile
Context config>qos>sap-ingress>fc
Description
This command, when enabled on a parent forwarding class, applies a color profile mode to the packets
stored in the queue associated with this forwarding class. The queue associated with the parent forwarding
class MUST be of type profile-mode.
When this QoS policy is applied to the ingress of a Frame Relay VLL SAP, the system will treat the received
FR frames with DE bit set as out-of-profile regardless of their previous marking as the result of the default
classification or on a match with an IP filter. It also adjusts the CIR of the ingress SAP queue to take into
account out-of-profile frames which were sent while the SAP queue was in the "< CIR" state of the bucket.
This makes sure that the CIR of the SAP is achieved in the long run.
All received DE=0 frames which are classified into this parent forwarding class or any of its sub-classes
have their profile unchanged by enabling this option. That is the DE=0 frame profile could be undetermined
Page 216
Any valid multipoint queue ID in the policy including 2 through 32.
11
7950 XRS Quality of Service Guide