Alcatel-Lucent 7950 Quality Of Service Manual page 235

use-fc-mapped-queue — This parameter overrides the policer's default egress queue destination to the
queue mapped by the traffic's forwarding class.
entry
Syntax entry entry-id [create]
no entry entry-id
Context config>qos>sap-ingress>ip-criteria
config>qos>sap-egress>ip-criteria
config>qos>sap-ingress>mac-criteria
Description This command is used to create or edit an criteria entry for the policy. Multiple entries can be created using
unique entry-id numbers.
The list of flow criteria is evaluated in a top down fashion with the lowest entry ID at the top and the highest
entry ID at the bottom. If the defined match criteria for an entry within the list matches the information in the
egress packet, the system stops matching the packet against the list and performs the matching entries
reclassification actions. If none of the entries match the packet, the IP flow reclassification list has no effect
on the packet.
An entry is not populated in the list unless the action command is executed for the entry. An entry that is not
populated in the list has no effect on egress packets. If the action command is executed without any explicit
reclassification actions specified, the entry is populated in the list allowing packets matching the entry to
exit the list, preventing them from matching entries lower in the list. Since this is the only flow
reclassification entry that the packet matched and this entry explicitly states that no reclassification action is
to be performed, the matching packet will not be reclassified.
The no form of this command removes the specified entry from the policy. Entries removed from the policy
are immediately removed from all services where that policy is applied.
Default
none
Parameters
entry-id — The entry-id, expressed as an integer, uniquely identifies a match criterion and the corresponding
action. It is recommended that multiple entries be given entry-ids in staggered increments. This allows
users to insert a new entry in an existing policy without requiring renumbering of all the existing
entries.
An entry cannot have any match criteria defined (in which case, everything matches) but must have at
least the keyword action fc fc-name for it to be considered complete. Entries without the action
keyword will be considered incomplete and hence will be rendered inactive.
Default
Values
create — Required parameter when creating a flow entry when the system is configured to require the
explicit use of the keyword to prevent accidental object creation. Objects may be accidentally created
when this protection is disabled and an object name is mistyped when attempting to edit the object. This
keyword is not required when the protection is disabled. The keyword is ignored when the flow entry
already exists.
7950 XRS Quality of Service Guide
none
1— 65535
Page 235