Alcatel-Lucent 7950 Quality Of Service Manual page 118

Network Ingress QoS Policy Commands
match
Syntax match [protocol protocol-id]
[no] match
Context config>qos>network>ingress>ip-criteria>entry
Description
This command creates a context to configure match criteria for an ingress network QoS policy
match criteria. When the match criteria have been satisfied the action associated with the match
criteria is executed.
If more than one match criteria (within one match statement) are configured then all criteria must
be satisfied (AND function) before the action associated with the match is executed.
A match context can consist of multiple match criteria, but multiple match statements cannot be
entered per entry.
It is possible that a network QoS policy includes the dscp map command, the dot1p map
command, and an IP match criteria. When multiple matches occur for the traffic, the order of
precedence is used to arrive at the final action. The order of precedence is as follows:
1. 802.1p bits
2. DSCP
3. IP Quintuple
The no form of this command removes the match criteria for the entry-id.
Parameters protocol protocol-idSpecifies an IP protocol to be used as an ingress network QoS policy match
criterion.
Values
Page 118
The protocol type such as TCP / UDP / OSPF is identified by its respective protocol
number. Well-known protocol numbers include ICMP(1), TCP(6), UDP(17).protocol-id: 0
— 255 protocol numbers accepted in DHB
keywords: none, crtp, crudp, egp, eigrp, encap, ether-ip, gre, icmp, idrp,igmp, igp, ip,
ipv6, ipv6-frag, ipv6-icmp, ipv6-no-nxt, ipv6-opts, ipv6-route, isis, iso-ip, l2tp, ospf-igp,
pim, pnni, ptp, rdp, rsvp, stp, tcp, udp, vrrp
* — udp/tcp wildcard
7950 XRS Quality of Service Guide