Alcatel-Lucent 7950 Quality Of Service Manual page 433

Parameters
multicast-queue
Syntax
Context
Description
Parameters
queue
Syntax
Context
Parameters
7950 XRS Quality of Service Guide
queue-id — The queue-id parameter must be an existing, multipoint queue defined in the
config>qos>sap-ingress context .
Values
17 — 24
multicast-queue queue-id
config>qos>shared-queue>fc
This command configures the multicast forwarding type queue mapping for fc fc-name. The specified
queue-id must exist within the policy as a multipoint queue before the mapping can be made. Once
the forwarding class mapping is executed, all multicast traffic on a SAP using this policy is forwarded
using the queue-id.
The multicast forwarding type includes the unknown unicast forwarding type and the broadcast for-
warding type unless each is explicitly defined to a different multipoint queue. When the unknown and
broadcast forwarding types are left as default, they will track the defined queue for the multicast for-
warding type.
The no form of the command sets the multicast forwarding type queue-id back to the default queue
for the forwarding class. If the broadcast and unknown forwarding types were not explicitly defined
to a multipoint queue, they will also be set back to the default multipoint queue (queue 11).
queue-id — The queue-id parameter specified must be an existing, multipoint queue defined in the the
config>qos>sap-ingress context.
Values
9 — 16
Default 11
queue queue-id
no queue
config>qos>shared-queue>fc
This command overrides the default unicast forwarding type queue mapping for fc fc-name. The
specified queue-id must exist within the policy as a non-multipoint queue before the mapping can be
made. Once the forwarding class mapping is executed, all unicast traffic (this includes all traffic, even
broadcast and multicast for services) on a SAP using this policy is forwarded using the queue-id.
The no form of this command sets the unicast (point-to-point) queue-id back to the default queue for
the forwarding class (queue 1).
queue-id — The queue-id parameter specified must be an existing, non-multipoint queue defined in
the config>qos>sap-ingress context.
Values
Any valid non-multipoint queue-id in the policy including 1 and 3 through 32 .
Default 1
Page 433