Alcatel-Lucent 7950 Quality Of Service Manual page 120

Network Ingress QoS Policy Commands
The no form of this command removes the DSCP match criterion.
Parameters
dscp-name — Specifies a dscp name that has been previously mapped to a value using the dscp-name
command. The DiffServ code point can only be specified by its name.
Values
dst-ip
Syntax dst-ip {ip-address/mask | ip-address netmask}
dst-ip {ipv6-address/prefix-length | ipv6-address ipv6-address-mask}
no dst-ip
Context config>qos>network>ingress>ip-criteria>entry>match
config>qos>network>ingress>ipv6-criteria>entry>match
Description This command configures a destination address range to be used as a network ingress QoS policy
match criterion.
To match on the destination address, specify the address and its associated mask, e.g., 10.1.0.0/16.
The conventional notation of 10.1.0.0 255.255.0.0 can also be used.
The no form of this command removes the destination IP address match criterion.
Parameters ip-address — The IP address of the destination IP or IPv6 interface. This address must be unique within the
subnet and specified in dotted decimal notation.
Values
Page 120
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15, cs2,
cp17, af21, cp19, af22, cp21, af23, cp23, cs3, cp25, af31, cp27, af32, cp29, af33, cp31,
cs4, cp33, af41, c p35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, ef, cp47,
nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57, cp58, cp59, cp60, cp61, cp62,
cp63
ip-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
prefix-length: 1 — 128
7950 XRS Quality of Service Guide