Alcatel-Lucent 7950 Quality Of Service Manual page 245

Default
No source IP match criterion.
Parameters
ip-address — Specifies the source IPv4 address specified in dotted decimal notation.
Values
mask — Specifies the length in bits of the subnet mask.
Values
ipv4-address-mask — Specifies the subnet mask in dotted decimal notation.
Values
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in QoS policies. An ip-prefix-list must
contain only IPv4 address prefixes and can only be used in SAP QoS policies applied to SAPs and time of
day suites.
prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special characters are
used, the string must be enclosed within double quotes.
ipv6-address — Specifies the IPv6 prefix for the IP match criterion in hex digits.
Values
prefix — Specifies the IPv6 prefix length for the ipv6-address expressed as a decimal integer.
Values
mask — Specifies the eight 16-bit hexadecimal pieces representing bit match criteria.
Values
src-port
Syntax src-port {lt | gt | eq} src-port-number
src-port range start end
no src-port
Context config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description
This command configures a source TCP or UDP port number or port range for a SAP QoS policy match
criterion.
The no form of this command removes the source port match criterion.
Default No src-port match criterion.
Parameters lt | gt | eq src-port-number — The TCP or UDP port numbers to match specified as less than (lt), greater
than (gt) or equal to (eq) to the source port value specified as a decimal integer.
Values
7950 XRS Quality of Service Guide
ip-address: a.b.c.d
1 — 32
a.b.c.d (dotted quad equivalent of mask length)
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
1 — 128
x:x:x:x:x:x:x (eight 16-bit pieces)
1 — 65535 (decimal)
Page 245