Alcatel-Lucent 7950 Quality Of Service Manual page 127

Network Egress QoS Policy Forwarding Class Commands
This command is used to redirect the FC of a packet of a PW or network IP interface to an egress
port queue-group.
It defines the mapping of a FC to a queue-id or a policer-id and a queue-id, and redirects the
lookup of the queue or policer of the same ID in some egress port queue-group instance. However,
the queue-group name and instance are explicitly provided only at the time the network QoS
policy is applied to egress context of a spoke-sdp or a network IP interface.
The no version of this command removes the redirection of the FC.
remarking
Syntax remarking
Context config>qos>network policy-id>egress
Description
dscp
Syntax dscp dscp-name fc fc-name
no dscp dscp-name
Context config>router>sgt-qos
Description This command creates a mapping between the DiffServ Code Point (DSCP) of the self generated
traffic and the forwarding class.
Self generated traffic that matches the specified DSCP will be assigned to the corresponding
forwarding class. Multiple commands can be entered to define the association of some or all sixty-
four DiffServ code points to the forwarding class.
All dscp name that defines a dscp value must be explicitly defined
The no form of this command removes the DiffServ code point to forwarding class association.
Default
none
Parameters
dscp-name — The name of the DiffServ code point to be associated with the forwarding class. DiffServ code
point can only be specified by its name and only an existing DiffServ code point can be specified. The
software provides names for the well known code points.
7950 XRS Quality of Service Guide Page 127