Alcatel-Lucent 7950 Quality Of Service Manual page 102

Network Queue QoS Policy Commands
Network Queue QoS Policy Queue Commands
queue
Syntax
queue queue-id
Context config>qos>network-queue
Description
This command enables the context to configure a QoS network-queue policy queue.
queue-id — The queue-id for the queue, expressed as an integer. The queue-id uniquely identifies the queue
Parameters
within the policy. This is a required parameter each time the queue command is executed.
Values
adaptation-rule
Syntax adaptation-rule
no adaptation-rule
Context config>qos>network-queue>queue
Description
This command defines the method used by the system to derive the operational CIR and PIR
settings when the queue is provisioned in hardware. For the CIR and PIR parameters individually,
the system attempts to find the best operational rate depending on the defined constraint.
The no form of the command removes any explicitly defined constraints used to derive the
operational CIR and PIR created by the application of the policy. When a specific adaptation-rule
is removed, the default constraints for pir and cir apply.
Default
adaptation-rule closest closest
Parameters
adaptation-rule — Specifies the adaptation rule to be used while computing the operational CIR or PIR
value.
Values
Page 102
pir — Defines the constraints enforced when adapting the PIR rate defined within the
queue queue-id rate command. The pir parameter requires a qualifier that defines the
constraint used when deriving the operational PIR for the queue. When the pir command
is not specified, the default applies.
cir — Defines the constraints enforced when adapting the CIR rate defined within the
queue queue-id rate command. The cir parameter requires a qualifier that defines the
7950 XRS Quality of Service Guide