Alcatel-Lucent 7950 Quality Of Service Manual page 255

queue queue-id — This parameter overrides the forwarding class default egress queue destination to a
specified queue-id. If port-redirect-group is not configred, then this will be a local SAP queue of that
queue-id. A queue of ID queue-id must exist within the egress QoS policy. If port-redirect-group-
queue is configured then the the queue queue-id in the egress port queue group instance is used.
Values
Default
group queue-group-name — The group queue-group-name is optional and is used to override the
forwarding class's default egress queue destination. If the queue group-queue-id parameter is not
specified, the forwarding class map within the specified group's template is used to derive which queue
within the group will receive the forwarding class's packets. An egress queue group template must exist
for the specified queue-group-name or the policer command will fail. The specified queue-group-name
must also exist as an egress queue group on the ports where SAPs and subscribers associated with the
sap-egress policy is applied or the policer command will fail.
Values
Default
queue group-queue-id — The queue group-queue-id is optional when the group queue-group-name
parameter is specified and is used to override the forwarding class mapping within the group's egress
queue group template. The specified group-queue-id must exist within the group's egress queue group
template or the policer command will fail.
Values
Default
instance instance-id — This parameter is used to specify the specific instance of a queue group with
template queue-group-name to which this queue should be redirected. This parameter is only valid for
queue groups on egress ports where policy based redirection is required.
Values
Default
description
Syntax description description string
no description
Context config>qos>sap-egress>policer
Description The description command is used to define an informational ASCII string associated with the policer
control policy. The string value can be defined or changed at any time once the policy exists.
The no form of this command is used to remove an explicit description string from the policer.
Default
no description
Parameters description string — The description-string parameter defines the ASCII description string for the policer
control policy. The description string can be up to 80 characters. If the string contains spaces, it must be
placed within beginning and ending double quotation marks. Beginning and ending quotation marks are
7950 XRS Quality of Service Guide
1—8
Derived from forwarding class assignment in queue-group definition.
Any qualifying egress queue group name
policer-output-queues
1—8
Derived from forwarding class assignment in queue-group definition
1 — 40960
1
Page 255