Alcatel-Lucent 7950 Quality Of Service Manual page 116

Network Ingress QoS Policy Commands
The no form of this command deletes all the entries specified under this node. Once IP criteria
entries are removed from a network ingress policy, the IP criteria is removed from all network
interfaces where that policy is applied.
This command is supported on FP2 and higher based hardware and is otherwise ignored.
action
Syntax action [fc fc-name] [profile {in | out}]
no action
Context config>qos>network>ingress>ip-criteria>entry
config>qos>network>ingress>ipv6-criteria>entry
Description
This mandatory command associates the forwarding class and packet profile with specific IP or
IPv6 criteria entry ID.
Packets that meet all match criteria within the entry have their forwarding class and packet profile
set based on the parameters included in the action parameters.
The action command must be executed for the match criteria to be added to the active list of
entries.
Each time action is executed on a specific entry ID, the previous entered values for fc fc-name and
profile are overridden with the newly defined parameters.
The no form of the command removes the entry from the active entry list. Removing an entry on a
policy immediately removes the entry from all network interfaces using the policy. All previous
parameters for the action are lost.
Default
Action specified by the default-action.
Values
Default
profile {in | out} — The profile reclassification action is mandatory. Packets matching the IP flow reclassification entry will
Page 116
fc fc-nameThe value given for fc fc-name must be one of the predefined forwarding
classes in the system. Specifying the fc fc-name is required. When a packet matches the
rule, the forwarding class is assigned to the specified forwarding class.fc: class
class: be, l2, af, l1, h2, ef, h1, nc
Inherit (When fc fc-name is not defined, the rule preserves the previous forwarding class
of the packet.)
7950 XRS Quality of Service Guide