Alcatel-Lucent 7950 Quality Of Service Manual page 114

Network Ingress QoS Policy Commands
Network Ingress QoS Policy Commands
ingress
Syntax ingress
Context config>qos>network policy-id
Description
This command is used to enter the CLI node that creates or edits policy entries that specify the
DiffServ code points to forwarding class mapping for all IP packets and define the MPLS EXP bits
to forwarding class mapping for all labeled packets.
When pre-marked IP or MPLS packets ingress on a network port, they get a Per Hop Behavior
(that is, the QoS treatment through the router-based on the mapping defined under the current
node.
default-action
Syntax default-action fc fc-name profile {in | out}
Context config>qos>network>ingress
Description
This command defines or edits the default action to be taken for packets that have an undefined
bits set. The default-action command specifies the forwarding class to which such packets are
assigned.
Multiple default-action commands will overwrite each previous default-action command.
Default
default-action fc be profile out
Parameters
fc fc-name — Specify the forwarding class name. All packets with DSCP value or MPLS EXPor dot1p bits
bits that is not defined will be placed in this forwarding class.
Default
Values
profile {in | out} — All packets that are assigned to this forwarding class will be considered in or out of
profile based on this command. In case of congestion, the in-profile packets are preferentially queued
over the out-of-profile packets.
Default
Values
Page 114
None, the fc name must be specified
be, l2, af, l1, h2, ef, h1, nc
None
in, out
7950 XRS Quality of Service Guide