Alcatel-Lucent 7950 Quality Of Service Manual page 125

Parameters
unknown-policer policer-id — TThe specified policer-id must exist within the queue-group template
applied to the ingress context of the forwarding plane.
Values
fp-redirect-group
Syntax fp-redirect-group policer policer-id
no fp-redirect-group policer
Context config>qos>network>ingress>fc
Description
This command is used to redirect the FC of a packet of a PW or network IP interface to an ingress
forwarding plane queue-group.
It defines the mapping of a FC to a policer-id and redirects the lookup of the policer of the same ID
in some ingress forwarding plane queue-group instance. However, the queue-group name and
instance are explicitly provided only at the time the network QoS policy is applied to the ingress
context of a spoke-sdp or a network IP interface.
The no version of this command removes the redirection of the FC.
Parameters
policer policer-id — The specified policer-id must exist within the queue-group template applied to the
ingress context of the forwarding plane.
Values
Network Egress QoS Policy Commands
egress
Syntax egress
Context config>qos>network policy-id
Description
This command is used to enter the CLI node that creates or edits egress policy entries that specify
the forwarding class to be instantiated when this policy is applied to the network port.
The forwarding class and profile state mapping to bits mapping for all packets are defined in this
context.
All out-of-profile service packets are marked with the corresponding out-of-profile bit value at
network egress. All the in-profile service ingress packets are marked with the corresponding in-
profile bit value based on the forwarding class they belong.
7950 XRS Quality of Service Guide
1—32
1—8
Page 125