Alcatel-Lucent 7950 Quality Of Service Manual page 234

Service Ingress QoS Policy Entry Commands
Values
Default
profile {in | out} — The profile reclassification action is optional. When specified, packets matching the IP
flow reclassification entry will be explicitly reclassified to either in-profile or out-of-profile regardless
of the ingress profiling decision. To remove the profile reclassification action for the IP flow
reclassification entry, the action command must be re-executed without the profile reclassification
action defined.
in — The in parameter is mutually excusive to the out parameter following the profile reclassification action
keyword. Either in or out must be specified when the profile keyword is present. When in is specified,
any packets matching the reclassification rule will be treated as in-profile by the egress forwarding
plane.
out — The out parameter is mutually excusive to the in parameter following the profile reclassification
action keyword. Either in or out must be specified when the profile keyword is present. When out is
specified, any packets matching the reclassification rule will be treated as out-of-profile by the egress
forwarding plane.
hsmda-counter-override counter-id — The hsmda-counter-override reclassification action is optional and
only has significance on SAPs which are created on an HSMDA. When specified, packets matching the
IP precedence value will be mapped to the defined HSMDA exception counter-id for the packets queue
group. The default behavior is to use the default counter on the queue group for the queue to which the
packet is mapped. The hsmda-counter-override action may be overwritten by an ip-criteria
reclassification rule match. The specified counter-id must be specified as an integer between 1 and 8. To
remove the ESMDA exception counter reclassification action for the specified dscp-value, the dscp
command must be re-executed without the hsmda-counter-override reclassification action defined. This
keyword is mutually exclusive with the redirection to a policer.
Values
Default
policer policer-id — When the action policer command is executed, a valid policer-id must be specified.
The parameter policer-id references a policer-id that has already been created within the sap-egress QoS
policy.
Values
Default
port-redirect-group-queue queue queue-id — Used to override the forwarding class default egress queue
destination to an egress port queue group. The specific egress queue group instance to use is specified at
the time that the QoS policy is applied to the SAP. Therefore, this parameter is only valid if SAP based
redirection is required. The queue parameter overrides the policer's default egress queue destination to a
specified queue-id in the egress port queue group instance is used.
Values
queue queue-id — This parameter overrides the policer's default egress queue destination to a specified
local SAP queue of that queue-id. A queue of ID queue-id must exist within the egress QoS policy.
Values
Page 234
fc: class[.sub-class]
class: be, l2, af, l1, h2, ef, h1, nc
sub-class: 29 characters max
none
1—8
None
1—63
none
1—8
1—8
7950 XRS Quality of Service Guide