Alcatel-Lucent 7950 Quality Of Service Manual page 242
Extensible routing system
Hide thumbs
Also See for 7950:
- Quality of service manual (912 pages) ,
- Configuration manual (778 pages) ,
- Basic system configuration manual (576 pages)
Table of Contents
Advertisement
IP QoS Policy Match Commands
policer. Since all lower priority traffic is discarded at the lower burst tolerance size, the remaining burst
tolerance defined by high-prio-only is available for the higher priority traffic.
The policer's mbs size defined in the QoS policy may be overridden on an sla-profile or SAP where the
policy is applied.
The no form of this command returns the policer to its default MBS size.
Default
None
Parameters
size [bytes | kilobytes] — The size parameter is required when specifying mbs and is expressed as an
integer representing the required size in either bytes or kilobytes. The default is kilobytes. The optional
byte and kilobyte keywords are mutually exclusive and are used to explicitly define whether size
represents bytes or kilobytes.
byte — When byte is defined, the value given for size is interpreted as the queue's MBS value given in
bytes.
kilobyte — When kilobytes is defined, the value is interpreted as the queue's MBS value given in kilobytes.
Values
Default
dst-ip
Syntax
dst-ip {ip-address/mask | ip-address ipv4-address-tmask | ip-prefix-list prefix-list-name]}
no dst-ip
Context
config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
config>qos>sap-egress>ipv6-criteria>entry>match
Description
This command configures a destination address range to be used as a SAP QoS policy match criterion.
To match on the IPv4 destination address, specify the address and its associated mask, e.g., 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 can also be used for IPv4.
The no form of this command removes the destination IPv4 address match criterion.
Default
No destination IP match criteria
Parameters
ip-address — Specifies the destination IPv4 address specified in dotted decimal notation.
Values
mask — Specify the length in bits of the subnet mask.
Values
ipv4-address-mask — Specify the subnet mask in dotted decimal notation.
Values
Page 242
1—39321600
kilobyte
ip-address:
a.b.c.d
prefix-length:
1 — 128
1 — 32
a.b.c.d (dotted quad equivalent of mask length)
7950 XRS Quality of Service Guide
Advertisement
Table of Contents
