Brake/Tail Light Assembly; Brake/Tail Light Assembly Removal And Installation; Bulb Replacement - Triumph Trophy Handbook

Maintenance and Adjustment

Brake/Tail Light Assembly

The brake/tail light, license plate light and
rear direction turn signals are incorporated in
a single assembly.
The brake/tail light unit is a sealed,
maintenance free LED unit. The direction
turn signal bulbs and license plate light bulb
can be replaced as described below:
Brake/Tail Light Assembly Removal
and Installation
1
chsw
1. R-clip
2. Wing nut
Remove the rear seat (see page 76).
Remove the R-clip and wing nut and detach
the brake/tail light assembly.
Installation is the reverse of the removal
procedure, noting the following:
• Tighten the plastic nut to 11.25 lbf-in
(1.25 Nm).
160

Bulb Replacement

1
3
chtj chtj
1. Turn signal bulb holders
2. License plate light bulb holder
2
3. Outer studs
Rear Direction Turn Signal Bulb
Replacement
Rotate the bulb holder connector away from
the outer stud to release it.
Replace the bulb.
Insert the bulb holder to the brake/tail light
unit and rotate towards the outer stud to
secure in the brake/tail light assembly.
License Plate Light Bulb Replacement
Carefully pull the bulb holder from the back
of the license plate light unit and remove the
bulb.
Installation is the reverse of the removal
procedure.
3
1
2