Assembly
1.
Position the cable to the motorcycle using the
same routing as noted during removal.
2.
Attach the inner cable to'the clutch lever and
actuating arm using a reversal of the removal
process.
3.
Refit the outer cable to the adjuster bracket at the
clutch end.
Note:
Ensure that the two adjuster nuts are
positioned, one either side of the bracket.
4.
Set the lever adjuster to a point where an equal
adjustment is possible in both directions.
5.
Set the adjuster at the clutch end to give a
preliminary setting of 2-3 mm of free play as
measured at the lever. Tighten the locknut.
6.
Operate the clutch lever several times and
recheck the amount of free-play present.
,
7.
Set the final adjustment of the cable to give 2-
3 mm of free-play at the lever by turning the
adjuster nut and lockn,ut at the lever end. Secure
the setting with the knurled locknut.
gaav
1
1. Clutch Lever
2.
Correct Setting, 2-3 mm
8.
Reconnect the battery positive (red) lead first.
9. Refit the seat (see page
16-9).
Disassembly
1.
Release the clutch cable from the actuating arm
(see page 4-5).
2.
Remove the starter cover, right hand crank cover
and associated starter gears to gain access to
the clutch cover bolt at the centre-right hand side
(see page 7-20).
1.
Right hand crank cover (starter cover removed)
2. Aluminium washer position
3.
Remove the clutch cover.
4.
Undo the bolts and springs and remove the
clutch pressure plate.
5. -Remove-the-clutch pull rod.
-
-
1. Clutch pull rod
Service Manual
-
Speed Triple