Cisco Nexus 7000 Series Command Reference Manual page 516

It
It
To specify a less-than group member for an IP port object group, use the lt command. A less-than group
member matches port numbers that are less than (and not equal to) the port number specified in the entry. To
remove a greater-than group member from port object group, use the no form of this command.
[ sequence-number ] lt port-number
no {sequence-number| lt port-number}
Syntax Description
sequence-number
port-number
Command Default
None
Command Modes
IP port object group configuration
Command History
Release
4.0(1)
Usage Guidelines
IP port object groups are not directional. Whether a lt command matches a source or destination port or
whether it applies to inbound or outbound traffic depends upon how you use the object group in an ACL.
This command does not require a license.
Examples
This example shows how to configure an IP port object group named port-group-05 with a group member
that matches traffic sent to or from port 1 through port 49151:
switch# configure terminal
switch(config)# object-group ip port port-group-05
switch(config-port-ogroup)# lt 49152
Cisco Nexus 7000 Series Security Command Reference
490
(Optional) Sequence number for this group member.
Sequence numbers maintain the order of group
members within an object group. Valid sequence
numbers are from 1 to 4294967295. If you do not
specify a sequence number, the device assigns a
number that is 10 greater than the largest sequence
number in the current object group.
Port number that traffic matching this group member
does not exceed or equal. Valid values are from 0 to
65535.
Modification
This command was introduced.
L Commands