Hardware Access-List Resource Pooling - Cisco Nexus 7000 Series Command Reference Manual

hardware access-list resource pooling

hardware access-list resource pooling
To allow ACL-based features to use more than one TCAM bank on one or more I/O modules, use the hardware
access-list resource pooling command. You can also enable flexible TCAM bank chaining feature with
PORT-VLAN or VLAN-VLAN modes. To restrict ACL-based features to using one TCAM bank on an I/O
module, use the no form of this command.
hardware access-list resource pooling [port-vlan| vlan-vlan] module {module-number| all}
no hardware access-list resource pooling [port-vlan| vlan-vlan] module {module-number| all}
Syntax Description
module
port-vlan
vlan-vlan
module-number
all
Command Default
None
Command Modes
Global configuration
Command History
Release
7.3(0)D1(1)
4.2(1)
4.1(2)
Cisco Nexus 7000 Series Security Command Reference
352
Specifies the module.
Specifies the port-vlan mode that allows you to
configure a single port feature and a single VLAN
feature on a destination per direction.
Specifies the vlan-vlan mode that allows you to
configure two VLAN features on a destination per
direction.
Specifies the I/O module(s). The slot-number-list
argument allows you to specify modules by the slot
number that they occupy. You can specify a single
I/O module, a range of slot numbers, or
comma-separated slot numbers and ranges.
Specifies all the modules. Note that the PORT-VLAN
and VLAN-VLAN modes are supported only on the
F3 modules. So, you cannot enable the flexible
TCAM bank chaining for all the modules.
Modification
This command was modified to support flexible bank chaining feature with
VLAN-VLAN and PORT-VLAN modes.
The hyphen was removed between the resource and pooling keywords.
This command was introduced.
H Commands