Cisco Nexus 7000 Series Command Reference Manual page 764

show cts interface
switch(config-if-cts-dot1x)# no propagate-sgt
switch(config-if-cts-dot1x)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
This example shows how to enable SGT propagation:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# cts dot1x
switch(config-if-cts-dot1x)# propagate-sgt
switch(config-if-cts-dot1x)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
This example shows how to enable SGT tagging exemption for the L2 control protocols.
switch# configure terminal
switch(config)# interface ethernet 2/27
switch(config-if)# cts manual
switch(config-if-cts-manual)# no propagate-sgt l2-control
This example displays the error message when you enable SGT tagging exemption for the L2 protocols on
non-supported modules:
switch# configure terminal
switch(config)# interface ethernet 7/2
switch(config-if)# cts manual
switch(config-if-cts-manual)# no propagate-sgt l2-control
ERROR: 'no propagate-sgt l2-control' is not allowed on any port of this line card type.
Related Commands
Command
cts dot1x
feature cts
show cts interface
Cisco Nexus 7000 Series Security Command Reference
738
Description
Enters Cisco TrustSec 802.1X configuration mode
for an interface.
Enables the Cisco TrustSec feature.
Displays the Cisco TrustSec configuration for
interfaces.
Show Commands