Remark - Cisco Nexus 7000 Series Command Reference Manual

R Commands

remark

To enter a comment into an IPv4, IPv6, or MAC access control list (ACL), use the remark command. To
remove a remark command, use the no form of this command.
[ sequence-number ] remark remark
no {sequence-number| remark remark}
Syntax Description
sequence-number
remark
Command Default
No ACL contains a remark by default.
Command Modes
IP access-list configuration
IPv6 access-list configuration
MAC access-list configuration
Command History
Release
4.1(2)
4.0(1)
(Optional) Sequence number of the remark
command, which causes the device to insert the
command in that numbered position in the access list.
Sequence numbers maintain the order of rules within
an ACL.
A sequence number can be any integer between 1 and
4294967295.
By default, the first rule in an ACL has a sequence
number of 10.
If you do not specify a sequence number, the device
adds the rule to the end of the ACL and assigns to it
a sequence number that is 10 greater than the
sequence number of the preceding rule.
Use the resequence command to reassign sequence
numbers to remarks and rules.
Text of the remark. This argument can be up to 100
alphanumeric, case-sensitive characters.
Modification
Support for the IPv6 access-list configuration mode was added.
This command was introduced.
Cisco Nexus 7000 Series Security Command Reference
remark
617