Cisco Nexus 7000 Series Security Command Reference - Cisco Nexus 7000 Series Command Reference Manual

C Commands
This example shows how to remove an SXP peer connection:
switch# configure terminal
switch(config)# no cts sxp connection peer 10.10.1.1
This example shows how to configure the hold-time for the SXPv4 protocol for each connection.
switch# configure terminal
switch(config)# cts sxp connection peer 10.20.2.2 password default mode local speaker
hold-time 500
Related Commands
Command
cts sxp default password
cts sxp default source-ip
feature cts
show cts sxp connection
Description
Configures the default SXP password for the device.
Configures the default SXP source IPv4 address for
the device.
Enables the Cisco TrustSec feature.
Displays the Cisco TrustSec SXP peer connection
information.

Cisco Nexus 7000 Series Security Command Reference

cts sxp connection peer
175