Cisco Nexus 7000 Series Command Reference Manual page 338

eq
eq
To specify a single port as a group member in an IP port object group, use the eq command. To remove a
single port group member from the port object group, use the no form of this command.
[ sequence-number ] eq port-number
no {sequence-number| eq port-number}
Syntax Description
sequence-number
port-number
Command Default
None
Command Modes
IP port object group configuration
Command History
Release
4.0(1)
Usage Guidelines
IP port object groups are not directional. Whether an eq command matches a source or destination port or
whether it applies to inbound or outbound traffic depends upon how you use the object group in an ACL.
This command does not require a license.
Examples This example shows how to configure an IP port object group named port-group-05 with a group member
that matches traffic sent to or from port 443:
switch# config t
switch(config)# object-group ip port port-group-05
switch(config-port-ogroup)# eq 443
Cisco Nexus 7000 Series Security Command Reference
312
(Optional) Sequence number for this group member.
Sequence numbers maintain the order of group
members within an object group. Valid sequence
numbers are from 1 to 4294967295. If you do not
specify a sequence number, the device assigns a
number that is 10 greater than the largest sequence
number in the current object group.
Port number that this group member matches. Valid
port numbers are from 0 to 65535.
Modification
This command was introduced.
E Commands