Ip Udp Relay Addrgroup - Cisco Nexus 7000 Series Command Reference Manual

ip udp relay addrgroup

ip udp relay addrgroup
To associate an object group with an L3 interface, use the ip udp relay addrgroup command.
ip udp relay addrgroup object-grp-name
no ip udp relay addrgroup object-grp-name
Syntax Description
object-grp-name
Command Default
None
Command Modes
Interface configuration
Command History
Release
7.3(0)D1(1)
Usage Guidelines
To use this command, you must configure an object group by using the object-group udp relay ip address
command.
Examples
This example shows how to associate an object group with an L3 interface:
switch(config)# interface ethernet e0/0
switch(config-if)# ip udp relay addrgroup udprelay1
This example shows how to disassociate the object group:
switch(config-if)# no ip udp relay addrgroup udprelay1
Related Commands
Command
ip forward-protocol udp
object-group udp relay ip address
Cisco Nexus 7000 Series Security Command Reference
426
Specifies the name of the object group.
Modification
This command was introduced.
Description
Enables the UDP relay feature.
Configures the object group.
I Commands