Cts Sxp Default Source-Ip - Cisco Nexus 7000 Series Command Reference Manual

cts sxp default source-ip

cts sxp default source-ip
To configure the default Security Group Tag (SGT) Exchange Protocol (SXP) source IPv4 address for the
device, use the cts sxp default source-ip command. To revert to the default, use the no form of this command.
cts sxp default source-ip ipv4-address
no cts sxp default source-ip ipv4-address
Syntax Description
ipv4-address
Command Default
None
Command Modes
Global configuration
Command History
Release
4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
You can use only IPv4 addressing with Cisco TrustSec.
This command requires the Advanced Services license.
Examples
This example shows how to configure the default SXP source IP address for the device:
switch# configure terminal
switch(config)# cts sxp default source-ip 10.10.3.3
This example shows how to remove the default SXP source IP address:
switch# configure terminal
switch(config)# no cts sxp default source-ip
Related Commands
Command
feature cts
show cts sxp
Cisco Nexus 7000 Series Security Command Reference
178
Default SXP IPv4 address for the device.
Modification
This command was introduced.
Description
Enables the Cisco TrustSec feature.
Displays the Cisco TrustSec SXP configuration
information.
C Commands