Dot1X Timeout Tx-Period - Cisco Nexus 7000 Series Command Reference Manual

dot1x timeout tx-period

dot1x timeout tx-period
To configure the 802.1X transmission-period timeout either globally or for an interface, use the dot1x timeout
tx-period command. To revert to the default, use the no form of this command.
dot1x timeout tx-period seconds
no dot1x timeout tx-period
Syntax Description
seconds
Command Default
Global configuration: 60 seconds
Interface configuration: Global configuration setting
Command Modes
Global configuration Interface configuration
Command History
Release
4.0(1)
Usage Guidelines
The 802.1X transmission-timeout period is the number of seconds that the Cisco NX-OS device waits for a
response to an EAP-request/identity frame from the supplicant before retransmitting the request.
You must use the feature dot1x command before you configure 802.1X.
Note You should change the default value only to adjust for unusual circumstances, such as unreliable links or
specific behavioral problems with certain supplicants and authentication servers.
This command does not require a license.
Examples This example shows how to configure the global 802.1X transmission-period timeout:
switch# configure terminal
switch(config)# dot1x timeout tx-period 45
This example shows how to revert to the default global 802.1X transmission-period timeout:
switch# configure terminal
switch(config)# no dot1x timeout tx-period
Cisco Nexus 7000 Series Security Command Reference
216
Number of seconds for the 802.1X
transmission-period timeout. The range is from 1 to
65535.
Modification
This command was introduced.
D Commands