Show Access-Lists - Cisco Nexus 7000 Series Command Reference Manual

show access-lists

show access-lists
To display all IPv4, IPv6, and MAC access control lists (ACLs) or a specific ACL, use the show access-lists
command.
show access-lists [ access-list-name ] [expanded| summary]
Syntax Description
access-list-name
expanded
summary
Command Default
None
Command Modes
Any command mode
Command History
Release
4.2(1)
4.1(2)
4.0(1)
Usage Guidelines
The device shows all ACLs unless you use the access-list-name argument to specify an ACL.
If you do not specify an ACL name, the device lists ACLs alphabetically by the ACL names.
The expanded keyword allows you to display the details of object groups used in an ACL rather than only
the name of the object groups. For more information about object groups, see the object-group ip address,
object-group ipv6 address, and object-group ip port commands.
The summary keyword allows you to display information about the ACL rather than the ACL configuration.
The information displayed includes the following:
• Whether per-entry statistics are configured for the ACL.
Cisco Nexus 7000 Series Security Command Reference
704
(Optional) Name of an ACL, which can be up to 64
alphanumeric, case-sensitive characters.
(Optional) Specifies that the contents of object groups
appear rather than the names of object groups only.
(Optional) Specifies that the command displays
information about the ACL. For more information,
see the "Usage Guidelines" section.
Modification
Command output is sorted alphabetically by the ACL names.
Support was added for the fragments command.
Support for IPv6 ACLs was added.
This command was introduced.
Show Commands