Nac Enable - Cisco Nexus 7000 Series Command Reference Manual

nac enable

nac enable
To enable Network Admission Control (NAC) on an interface, use the nac enable command. To disable NAC,
use the no form of this command.
nac enable
no nac enable
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Interface configuration
Command History
Release
4.0(1)
Usage Guidelines
You must use the feature eou command and set the switchport mode to access before using the nac enable
command.
You can enable EAPoUDP only on an access mode interface.
This command does not require a license.
Examples This example shows how to enable NAC on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# switchport
switch(config-if)# switchport mode access
switch(config-if)# nac enable
This example shows how to disable NAC on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# no nac enable
Related Commands
Command
feature eou
show eou
Cisco Nexus 7000 Series Security Command Reference
512
Modification
This command was introduced.
Description
Enables EAPoUDP.
Displays EAPoUDP information.
N Commands