Cts L3 Spi (Interface) - Cisco Nexus 7000 Series Command Reference Manual

C Commands

cts l3 spi (interface)

To enable Layer 3 Cisco TrustSec and configure a security parameter index (SPI) on an interface, use the cts
l3 spi command. To revert to the default, use the no form of this command.
cts l3 spi spi-number
no cts l3
Syntax Description
spi-number
Command Default
Disabled
Command Modes
Global configuration
Command History
Release
4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
This example shows how to enable Layer 3 Cisco TrustSec for an interface:
switch# config t
switch(config)# interface ethernet 2/3
switch(config-if)# cts l3 spi 3 10.10.1.1/23
This example shows how to disable Layer 3 Cisco TrustSec for an interface:
switch# config t
switch(config)# interface ethernet 2/3
switch(config-if)# no cts l3
Related Commands
Command
cts l3 spi (global)
feature cts
SPI for the interface. The range is from 0 to
429496729.
Modification
This command was introduced.
Description
Enables the Layer 3 Cisco TrustSec for the device.
Enables the Cisco TrustSec feature.
Cisco Nexus 7000 Series Security Command Reference
cts l3 spi (interface)
123