Show Ip Udp Relay - Cisco Nexus 7000 Series Command Reference Manual

Show Commands

show ip udp relay

To display the configuration details of the UDP relay feature, use the show ip udp relay command.
show ip udp relay [interface [ethernet slot/port-number| port-channel port-channel-number]| object-group
object-group-name]
Syntax Description
slot/port-number
port-channel-number
object-grp-name
Command Default
None
Command Modes
Any command mode
Command History
Release
7.3(0)D1(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to display the details of the UDP relay feature:
switch# show ip udp relay
UDP relay service is enabled
UDP relay on default UDP ports:
Default UDP Ports Status
--------------------------- -------------
Time service
IEN-116 Name Service
TACACS service
Domain Naming System
Trivial File Transfer Protocol (port 69 ) enabled
NetBIOS Name Server
NetBIOS Datagram Server
UDP relay is enabled on the following non-default UDP ports:
-----------------------------------------------------------------
Object-group and Subnet-broadcast configurations:
Interface Subnet-broadcast Object-group
---------- ---------------- ------------
Vlan700 disabled iSmart
Vlan800 enabled iHello
Specifies the slot and port number.
Specifies the port channel number.
Specifies the name of the object group.
Modification
This command was introduced.
(port 37 ) enabled
(port 42 ) enabled
(port 49 ) enabled
(port 53 ) enabled
(port 137) enabled
(port 138) enabled
Cisco Nexus 7000 Series Security Command Reference
show ip udp relay
805