Cisco Nexus 7000 Series Command Reference Manual page 561

P Commands
destination
eq
gt
lt
neq
portgroup
range
capture session
session
Command Default
None
Command Modes
ACL configuration mode
Command History
Release
5.2(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to enable a capture session for the access control entries (ACEs) of the access control
list:
switch# configure terminal
switch(config)# ip access-list acl-1
switch(config-acl)# permit tcp host 10.1.1.1 any capture session 10
switch(config-acl)#
Destination network address.
(Optional) Matches only packets on a given port
number.
(Optional) Matches only packets with a greater port
number.
(Optional) Matches only packets with a lower port
number.
(Optional) Matches only packets not on a given port
number.
(Optional) Specifies the source port group.
(Optional) Matches only packets in the range of port
numbers.
Specifies a capture session for the ACEs.
Session ID. The range is from 1 to 48.
Modification
This command was introduced.
Cisco Nexus 7000 Series Security Command Reference
permit (ACL)
535