Cts Sxp Connection Peer - Cisco Nexus 7000 Series Command Reference Manual

C Commands

cts sxp connection peer

To configure a Security Group Tag (SGT) Exchange Protocol (SXP) peer connection for Cisco TrustSec, use
the cts sxp connection peer command. To remove the SXP connection, use the no form of this command.
cts sxp connection peer ipv4-address [sourcesource-ip-address password {default| none| required} mode
{local| peer} [[[listener| speaker] [hold-time minimum-time maximum-time]]| both [vrf vrf-name]]
no cts sxp connection peer ipv4-address {source| password} {default| none} mode {local| peer} [[[listener|
speaker] [hold-time minimum-time maximum-time| vrf vrf-name]]| both [vrf vrf-name]]
Syntax Description
peer-ipv4-addr
source src-ipv4-addr
password
default
none
required
password
7 encrypted password
mode
speaker
listener
vrf vrf-name
IPv4 address of the peer device.
(Optional) Specifies the IPv4 address of the source
device.
Specifies the password option to use for the SXP
authentication.
Specifies that SXP should use the default SXP
password for the peer connection.
Specifies that SXP should not use a password.
Specifies the password that SXP should use for this
peer connection.
Clear text password. The password is alphanumeric
and case-sensitive. The maximum length is 32
characters.
Specifies an encrypted password. The maximum
length is 32 characters.
Specifies the mode of the peer device.
Specifies that the peer is the speaker.
Specifies that the peer is the listener.
(Optional) Specifies the VRF for the peer.
Cisco Nexus 7000 Series Security Command Reference
cts sxp connection peer
173