Dot1X Default - Cisco Nexus 7000 Series Command Reference Manual

dot1x default

dot1x default
To reset the 802.1X global or interface configuration to the default, use the dot1x default command.
dot1x default
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Global configuration Interface configuration
Command History
Release
4.0(1)
Usage Guidelines
You must use the feature dot1x command before you configure 802.1X.
This command does not require a license.
Examples This example shows how to set the global 802.1X parameters to the default:
switch# configure terminal
switch(config)# dot1x default
This example shows how to set the interface 802.1X parameters to the default:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# dot1x default
Related Commands
Command
feature dot1x
show dot1x
Cisco Nexus 7000 Series Security Command Reference
274
Modification
This command was introduced.
Description
Enables the 802.1X feature.
Displays 802.1X feature status information.
D Commands