Show Port-Security Interface - Cisco Nexus 7000 Series Command Reference Manual

Show Commands

show port-security interface

To show the state of port security on a specific interface, use the show port-security interface command.
show port-security interface {port-channel channel-number| ethernet slot/port}
Syntax Description
port-channel channel-number
ethernetslot/port
Command Default
None
Command Modes
Any command mode
Command History
Release
4.2(1)
4.0(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to use the show port-security interface command to view the status of the port
security feature on the Ethernet 1/4 interface:
switch# show port-security interface ethernet 1/4
Port Security
Port Status
Violation Mode
Aging Time
Aging Type
Maximum MAC Addresses
Total MAC Addresses
Configured MAC Addresses
Sticky MAC Addresses
Security violation count
switch#
Specifies a Layer 2 port-channel interface. The
channel-number argument can be a whole number
from 1 to 4096.
Specifies an Ethernet interface.
Modification
Support for Layer 2 port-channel interfaces was added.
This command was introduced.
: Enabled
: Secure Down
: Shutdown
: 0 mins
: Absolute
: 5
: 1
: 1
: 0
: 0
Cisco Nexus 7000 Series Security Command Reference
show port-security interface
855