Tacacs-Server Test - Cisco Nexus 7000 Series Command Reference Manual

tacacs-server test

tacacs-server test
To monitor the availability of all TACACS+ servers without having to configure the test parameters for each
server individually, use thetacacs-server test command. To disable this configuration, use the no form of
this command.
tacacs-server test {idle-time time| password password| username name}
no tacacs-server test {idle-time time| password password| username name}
Syntax Description
idle-time time
password password
username name
Command Default
Server monitoring: Disabled
Idle time: 0 minutes
Test username: test
Test password: test
Command Modes
Global configuration
Command History
Release
5.0(2)
Usage Guidelines
To use this command, you must enable TACACS+ authentication.
Any servers for which test parameters are not configured are monitored using the global level parameters.
Cisco Nexus 7000 Series Security Command Reference
950
Specifies the time interval (in minutes) for monitoring
the server. The range is from 1 to 1440 minutes.
Note When the idle time interval is 0 minutes,
periodic TACACS+ server monitoring is not
performed.
Specifies a user password in the test packets. The
password is alphanumeric, case sensitive, and has a
maximum of 32 characters.
Specifies a username in the test packets. The name is
alphanumeric, not case sensitive, and has a maximum
of 32 characters.
To protect network security, we recommend
Note
that you use a username that is not the same
as an existing username in the TACACS+
database.
Modification
This command was introduced.
T Commands