Cisco Nexus 7000 Series Command Reference Manual page 532

match (class-map)
Command Default
None
Command Modes
Class map configuration
Command History
Release
6.2(10)
4.0(3)
4.0(1)
Usage Guidelines
You must create the IP ACLs or MAC ACLs before you reference them in this command.
You can use this command only in the default VDC.
This command does not require a license.
Examples This example shows how to specify a match criteria for a control plane class map:
switch# configure terminal
switch(config)# class-map type control-plane ClassMapA
switch(config-pmap)# match exception ip icmp redirect
switch(config-pmap)# match redirect arp-inspect
This example shows how to remove a criteria for a control plane class map:
switch# configure terminal
switch(config)# class-map type control-plane ClassMapA
switch(config-pmap)# no match exception ip icmp redirect
Related Commands
Command
class-map type control-plane
show class-map type control-plane
Cisco Nexus 7000 Series Security Command Reference
506
Modification
The unicast rpf-failure keywords were added.
Added support for policing IPv6 packets.
This command was introduced.
Description
Creates or specifies a control plane class map and
enters class map configuration mode.
Displays configuration information for control plane
policy maps.
M Commands