Cisco Nexus 7000 Series Command Reference Manual page 385

H Commands
Usage Guidelines
Glean fast-path is enabled by default. If glean fast-path programming does not occur due to adjacency resource
exhaustion, the system falls back to regular glean programming.
The hardware rate-limiter layer-3 glean-fast {packets | disable} [module module [port start end]] command
sends packets to the supervisor from F2e, M1, or M2 Series modules.
The hardware rate-limiter portgroup-multiplier multiplier module module command applies the multiplier
to the rate limit. For example, if you configured the ttl rate-limiter as 1000 pps and the multiplier value was
0.5, each ASIC instance would be programmed with 500 pps.
This command does not require a license.
Examples This example shows how to configure a rate limit for control packets:
switch# configure terminal
switch(config)# hardware rate-limiter layer-3 control 20000
This example shows how to revert to the default rate limit for control packets:
switch# configure terminal
switch(config)# no hardware rate-limiter layer-3 control
This example shows how to configure the port group multiplier:
switch# configure terminal
switch(config)# hardware rate-limiter portgroup-multiplier 0.5 module 3
Related Commands
Command
clear hardware rate-limiter
show hardware rate-limiter
show running-config
Description
Clears rate-limit statistics.
Displays rate-limit information.
Displays the running configuration.
Cisco Nexus 7000 Series Security Command Reference
hardware rate-limiter
359