Server - Cisco Nexus 7000 Series Command Reference Manual

server

server
To add a server to a RADIUS, TACACS+, or Lightweight Directory Access Protocol (LDAP) server group,
use the server command. To delete a server from a server group, use the no form of this command.
server {ipv4-address| ipv6-address| hostname}
no server {ipv4-address| ipv6-address| hostname}
Syntax Description
ipv4-address
ipv6-address
hostname
Command Default
None
Command Modes
RADlUS server group configurationTACACS+ server group configurationLDAP server group configuration
Command History
Release
5.0(2)
4.0(1)
Usage Guidelines
You can configure up to 64 servers in a server group.
Use the aaa group server radius command to enter RADIUS server group configuration mode, the aaa
group server tacacs+ command to enter TACACS+ server group configuration mode, or the aaa group
server ldap command to enter LDAP server group configuration mode.
If the server is not found, use the radius-server host command, tacacs-server host command, or ldap-server
host command to configure the server.
Note You must use the feature tacacs+ command before you configure TACACS+ and the feature ldap
command before you configure LDAP.
This command does not require a license.
Cisco Nexus 7000 Series Security Command Reference
648
Server IPv4 address in the A.B.C.D format.
Server IPv6 address in the X:X:X::X format.
Server name. The name is alphanumeric, case
sensitive, and has a maximum of 256 characters.
Modification
Support for LDAP server groups was added.
This command was introduced.
S Commands