Ip Forward-Protocol Udp - Cisco Nexus 7000 Series Command Reference Manual

ip forward-protocol udp

ip forward-protocol udp
To enable the UDP relay feature, use the ip forward-protocol udp command.
ip forward-protocol udp [ port-range ]
no ip forward-protocol udp [ port-range ]
Syntax Description
port-range
Command Default
Disabled
Command Modes
Global configuration
Command History
Release
7.3(0)D1(1)
Usage Guidelines
To use this command, you must enable the DHCP feature by using the feature dhcp command.
Examples
This example shows how to enable the UDP relay feature:
switch# configure terminal
switch(config)# ip forward-protocol udp
This example shows how to disable the UDP relay feature:
switch# configure terminal
switch(config)# no ip forward-protocol udp
Related Commands
Command
ip udp relay subnet-broadcast
object-group udp relay ip address
Cisco Nexus 7000 Series Security Command Reference
418
Specifies the range of UDP ports to enable the UDP
relay feature. The range is from 0 to 65535.
Modification
This command was introduced.
Description
Enables the UDP relay feature for the subnet
broadcasts.
Configures an object group containing IP addresses.
I Commands