Cisco Nexus 7000 Series Security Command Reference - Cisco Nexus 7000 Series Command Reference Manual

cts sxp connection peer
hold-time minimum-time maximum-time
Command Default
The CTS-SXP peer IP address is not configured and no CTS-SXP peer password is used for the peer connection.
The default setting for a CTS-SXP connection password is none.
Command Modes
Global configuration
Command History
Release
8.0(1)
4.1(3)
4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
You can use only IPv4 addressing with Cisco TrustSec.
If you do not specify a source IPv4 address, you must configure a default SXP source IPv4 address using the
cts sxp default source-ip command.
If you specify default as the password mode, you must configure a default SXP password using the cts sxp
default password command.
This command requires the Advanced Services license.
Examples This example shows how to configure an SXP peer connection:
switch# configure terminal
switch(config)# cts sxp connection peer 10.10.1.1 source 10.10.2.2 password default mode
listener

Cisco Nexus 7000 Series Security Command Reference

174
(Optional) Specifies the hold-time period, in seconds,
for the device. The range for minimum and maximum
time is from 0 to 65535.
A maximum-time value is required only when you
use the following keywords: peer speaker and local
listener. In other instances, only a minimum-time
value is required.
Note
Modification
This command was modified. The hold-time keyword and minimum-time
and maximum-time arguments were added.
Added the 7 option to allow encrypted passwords.
This command was introduced.
If both minimum and maximum times are
required, the maximum-time value must be
greater than or equal to the minimum-time
value.
C Commands